Becker Indianapolis Pro 7952 Installation Guide download pdf (Page 93)

Technical data

• Wavebands:

FM 87.5 MHz - 108 MHz

MW 531 kHz - 1620 kHz

LW 153 kHz - 282 kHz

SW 5800 kHz - 6250 kHz

• Frequency range:

20 Hz - 20 kHz for CD-mode

30 Hz - 15 kHz for FM

50 Hz - 2.5 kHz for MW, LW, SW

• Output:

4 x 18 Watt

• Line cross section:

0.75 mm² min.

• Loudspeaker impedance:

min. 4 Ω

• Line out:

4 x analog Line Out (Va max 3Veff at

10 kΩ)

• GAL:

In order to utilise the GAL, a square

wave voltage with a mass-related am-

plitude of +4 V to +12 V must be pro-

vided by the vehicle’s electronic

speedometer. Volume is increased in

15 increments of 1.25dB each.

• Antenna:

Impedance 50 Ω

• AF telephone input:

Max. input voltage 8 V (if interference

occurs, a commercially available 1 : 1

repeater should be connected into the

signal cable).

• AUX input:

16 KΩ Input resistance, max. input

voltage 1.7 Veff

• Telephone mute:

Low active level < 2 Volt

• Supply voltage:

12 Volt

• CD Connection:

Becker Silverstone 2630, Silverstone

2640, Silverstone 2660 and Silver-

stone 7860 CD changers can be con-

nected.

• Playable CDs:

Only CDs which comply with DIN

EN 60908 can be used. The use of

8 cm CDs with an adapter is not rec-

ommended

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 122 123

Comments to this Manuals

No comments

Becker Indianapolis Pro 7952 Installation Guide Page 93

Comments to this Manuals

Related products and manuals for Car media receivers Becker Indianapolis Pro 7952