Installation Guide
120
Status of the calibration journey (
CALIBRATION RIDE)
In the Service Mode, select
CALIBRATION RIDE with the right rota-
ry control and press to confirm.
The calibration status (i.e.
STATUS: 2) and the type of positioning
(i.e.
3D) are displayed. After calibration is completed, instead of
WHEEL and REV., the road currently being driven on is displayed (pro-
vided it is included in the digital map).
Testing the system components (
MODULE TEST)
A test program automatically tests the internal components of the navi-
gation system.
In the Service Mode, select
MODULE TEST with the right rotary
control and press to confirm.
If
OK is displayed, press the button. The unit switches back to the
Service Mode.
Function test of the GAL signal, reverse signal, unit-internal sen-
sors (
SENSORS )
• In the Service Mode, select
SENSORS with the right rotary
control and press to confirm.
• Move the vehicle several metres forwards or backwards for the
GAL signal function test.
The number value after WHEEL must increase (also at low
speed).
The number value after
WHEEL should not increase when the
vehicle is in neutral or when the accelerator is pressed while the
vehicle is parked.
Comments to this Manuals