19
Navigation mode
If a definite entry is given, the system
switches to the Road/ Centre Entry. If
there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
The location distinguishing list is dis-
played if the selection is ambiguous.
X Select the required location using the
right rotary control and press the
control to confirm.
The program returns to the Road or Cen-
tre Entry.
If there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
Selecting destination via post
code
The destination can also be selected via
the town’s post code.
X Select the destination's POST CODE
by turning the right rotary control
and press to confirm the selection.
X Using the right rotary control , enter
the post code for the destination and
press for more than 2 seconds to con-
firm the entry. To confirm, the small
tick can also be selected and the
right-hand rotary control pressed
briefly.
The display then shows either the desti-
nation corresponding to the post code or,
if the post code is shared among several
towns, a list containing these towns.
X Select the required location using the
right rotary control and press to
confirm.
If more than 9 locations share the same
post code, the display will show the lo-
cation input menu instead of the above-
mentioned list. In that case, the town
name is to be entered as described in
“Entering a destination” on page 18.
The program returns to road or centre
entry. If there are no roads in the select-
ed town or only the centre can be select-
ed, the unit will switch directly to the
route menu.
Comments to this Manuals