Becker Indianapolis Pro 7952 Installation Guide download pdf (Page 109)

Installation Guide

109

Installation/Removal of the unit

• Installation:

A universal bracket for DIN installation slots is integrated into this

unit. An installation frame is not required. The unit is inserted into

the installation slot and secured with the slides supplied.

To install, complete all electrical connections. Then push the unit

into the installation slot. Subsequently, insert slides into the open-

ings on the front of the unit until the first detent position (Fig. A).

Now lock the radio in by pulling on both slides as shown in Fig. B.

Subsequently, remove the slides.

• Removal:

To remove the unit, it must first be unlocked. To do this, push in

both slides to the second detent position as shown in Figure A.

Subsequently, withdraw the unit with both slides (Fig. C). Then re-

move the slides by pressing the springs on the right and left sides

of the unit.

If the unit was previously installed in another vehicle, it may be

necessary to adjust the springs on the unit before installation. To

adjust the springs, insert slide as shown in Fig. D and subsequently

adjust as shown in Fig. E (gently press slide in the direction of 1

while at the same time moving the slide in the direction of 2).

The installation angle of the unit must not exceed 0° to +35° or

+55° - +90° depending on the type of device.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 122 123

No comments

Becker Indianapolis Pro 7952 Installation Guide Page 109